Woodland wildfire and protecting your property

April 29, 2007 at 2:29 pm Leave a comment

Forest fires are classified as surface, crown, or ground fires based on their manner of spread.  Most forest fires in the Midwest are surface fires. They burn only the litter and other small fuels on the forest floor. They may scar the base of large trees and kill small trees.

Crown fires

Crown fire

Crown fire. MNICS image.

Crown fires usually start as surface fires that reach into the canopy with the help of dry winds and fuel ladders. They occur most often in conifer stands and are very damaging and difficult to control. An intense crown fire will produce showers of sparks and glowing embers that easily jump firebreaks and set additional fires well in advance of the leading edge. Although conifer crowns frequently catch fire, true crown fires that spread through the air from one crown to the next are fairly rare.

Ground Fires

A ground fire burns and smolders below the surface sometimes going undetected for days or weeks. It consumes soil high in organic matter including dried peat and thick litter. It produces enough heat to kill most of the trees in its path by cooking their root systems. Such a fire may cross firebreaks through roots and dry organic matter. Ground fires are very difficult to control, but are likely to occur only in dry years.

Firewise.org photo: defensible space

http://www.firewise.org photo: Defensible space

Few woodland owners can afford their own fire suppression equipment. Instead, most rely on state and local agencies to control fires. While these organizations respond quickly, there may be some delay before the fire is reported and crews arrive on the scene. For this reason you need to maintain your land so wildfires cause minimal damage before they are suppressed. The following practices will help:

  • Maintain a cleared firebreak around your woodland. A firebreak might consist of a rough bulldozed road with a bare mineral soil surface that can be driven by a four-wheel drive fire truck. Although such a firebreak may stop a surface fire, it is more likely to be a good starting place for a fire suppression crew to build a fire line.
  • If the woodland is more than 20 acres, consider establishing a trail/road system within it to provide access to all areas and break it into smaller, more defensible units. The road system also may provide access for other management activities or recreation.
  • Create a pond. This will provide water for fire suppression and may benefit wildlife.
  • Thin and prune pine and spruce-fir stands to keep stands from building fuel ladders (a ladder fuel is a fuel that will carry a surface fire into the crowns) that permit a surface fire to climb into the tree crowns.
  • Create buffer strips of hardwoods around conifers for added protection. Hardwood stands are less flammable than conifer stands and also may diversify wildlife habitat.
  • After timber harvests, lop or chip slash so that it lies close to the ground and decays quickly. You can also pile and burn slash, but take care not to start a wildfire.
  • Cooperate with adjacent landowners in designing and establishing fire prevention measures.
  • Place fire prevention and suppression clauses in logging contracts.

You can learn much more about reducing your fire risk at the DNR Firewise site.

Controlled Burning

Prescribed burn - Flickr photo by devlandt

Flickr photo by devlandt. Click for original.

Controlled burns are fires set intentionally under specific fuel and weather conditions. They can be used in established stands to change the quantity and species of understory vegetation, thus enhancing the growth of overstory trees or benefiting wildlife. They can be used to reduce fuel loads that contribute to wildfire hazard. On recently harvested sites they are used to kill or set back the growth of undesirable trees and shrubs and to eliminate woody debris that hinders access for planting trees or that may harbor insect and disease pests.

The soil chemistry and physical processes on a burn site change temporarily, but will return to normal. However, a poorly planned or improperly controlled burn may kill crop trees. Consult a forester in regard to firebreak placement, weather requirements, tools needed, legal liabilities, and other important aspects. DNR foresters and wildlife managers will be able to assist you in determining if a burn plan is appropriate for the goals you have for your property. A controlled burn always poses some risk, but it should remain an option if it fits into your management plan.

Advertisements

Entry filed under: forest health. Tags: , , , , , , , , , , , , , , , , , , .

Cost-sharing for Minnesota woodlands Woodland invasive species in Minnesota

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

Trackback this post  |  Subscribe to the comments via RSS Feed


About this blog

News and information of interest to Minnesota woodland owners. Sister site to MyMinnesotaWoods.org.

In the news...


%d bloggers like this: